Return to snowjoe.com
Snow Joe Support Knowledge Base Snow Joe Knowledge Base
How do I assemble my Multi-Purpose Spreader?
Joe's Assistant
1 months ago
  1. Turn the spreader upside down.
  2. Install the stand onto the frame of the spreader using two sets of M6x40 carriage bolts, curved washers and lock nuts.
  3. Install one of the handle supports onto the frame of the spreader using two sets of M6x40 carriage bolts, curved washers and lock nuts. Do the same for the other side. NOTE: Do not tighten the lock nuts yet.
  4. Turn the spreader right side up.
  5. Slide the end of the handle between the two handle supports and fix it in place using two sets of M6x45 carriage bolts, curved washers and lock nuts.
  6. Using the provided wrenches, tighten the four lock nuts holding both handle supports to the frame of the spreader
  7. Attach the shorter end of the control rod to the feed plate lever on the back of the spreader using a M6x16 hex bolt, nylon washer and lock nut.
  8. Fix the other end of the control rod to the control lever on the handle using an M6x16 hex bolt, nylon washer and lock nut.
  9. At this point, the control lever assembly is still only loosely attached to the handle. With the control lever set to the closed setting (all the way back), push the entire control lever assembly down until the hole in the bottom of the hopper is completely closed by the feed plate, before tightening the two bolts.
Was this article helpful? 0 0
More questions? Submit a request

SJ-WBS70 Related Articles

How do I assemble my Multi-Purpose Spreader?
How do I correctly operate my Multi-Purpose Spreader?
How do I maintain and store my Multi-Purpose Spreader?

We're Here to Help

Chat with us any time

Click here to send us a message.

Email us Anytime

Submit your help request here.

Connect with us on Social

Select a social media channel and message us.

Call us

Call us Mon-Fri 9AM-8PM EST and Sat-Sun 9AM-5PM EST toll free at
1-866-766-9563.