Snow Joe Support Knowledge Base Snow Joe Knowledge Base

1. To fit or change the blade, place the grass shear + hedge trimmer on a hard surface. Turn the unit upside down in one hand and use the other hand to gently lift the tab of the blade cover. Slide the tab back until the cover can be removed
2. Gently remove the blade by lifting the end tip of the blade off of the grass shear + hedge trimmer unit
3. Insert the desired blade into the base of the motor housing
4. Align the gear shaft in the middle of the blade with the gear in the middle of the unit. Align the four (4) lugs so that the blade lays flat against the housing for a secure fit
5. Once the blade is in position, replace the blade cover by aligning the cover with the slots on the base of the motor housing
6. Push forward on the blade cover until it slides and clicks into place. The grass shear + hedge trimmer is now ready for use

NOTE: You may need to manually move the blade or gear shaft in order to align the gear shaft with the gear in the center of the unit.